Installing Foxii Corner Guards

Installing Foxii is pretty easy:

Step 1: Clean the surface of the corner, by wiping it down with a damp cloth or paper towel to remove any dust, dirt, food, oil, or debris. Wipe dry.

Step 2: Peel the 3M paper backing from the interior of the Foxii corner guard. There are three individual papers to remove; interior left, interior right, and interior top panel.

Step 3: Hold the top of the Foxii corner guard, and position the corner guard to the edge of the table, frame, or wall. Apply firm pressure to the entire surface of the corner guard to ensure a firm bond. Hold tight for 30 seconds to ensure firm application, and to maintain a tight adhesion
to the corner.

Cleaning the exterior of Foxii is also pretty easy:

Step 1: Wipe down with warm water and a neutral detergent.

Step 2: That’s it. That’s the post. We use 3M tape to ensure that Foxii goes on, and stays on. Make sure you cleaning the surfaces well before you apply the adhesive because if its dirty sometimes it can peel off. Press hard for those 30s, because you only get one shot, one opportunity, to seize everything you ever wanted, in one moment. #momsspaghetti

Kids can be crafty though, we know, and if they want to, after enough pulls on that little fox they may have ¾ of a new silicone bouncy ball. If it falls off, you have a few options – you can purchase some 3M tape at any hardware store and give it another go. You can superglue that puppy down (RIP table). Or you can reach out to our customer service team hello@quarkbaby.com and we can try our best to help you out and avoid leaving you with a unconventional toy to test out your haphazard juggling skills.